SASimul Ahmed
All work
FabricationFabLab KUET2024 – 2026

Cirqoid CNC PCB Mill: Restoration and New Controller

Brought an abandoned PCB mill back to life, then started replacing its controller

FabLab KUET's Cirqoid PCB mill had sat unused and its manufacturer had shut down. I got it milling again with a custom G-code workflow, pushed it to 0.15 mm trace and clearance for a researcher's antenna, and am now designing a replacement GRBL controller board after its original controller failed.

Role
Restoration lead
CNCG-codeFlatCAMgrblHAL / GRBLStepper driversReverse engineering
0.15 mm
trace / clearance milled
2
restoration phases

Version history

First prototype of the new controller: Arduino Nano, stepper drivers and a buck converter
First prototype of the new controller: Arduino Nano, stepper drivers and a buck converter1 / 2
Phase 2In progress

GRBL controller redesign

Jun 2026 – present

The original controller got stuck in a homing loop and has no firmware support. After a slow grblHAL port, I am designing a new GRBL controller: four stepper drivers, buttons, limit switches and isolation. While tracing the spindle I found its BLDC driver hidden inside the spindle housing.

  • Schematic verified against the original components
  • Reverse-engineered the hidden BLDC spindle driver
  • First prototype of the new controller built and powered on the bench
Firmware
GRBL (grbl-custom)

Next project

altium-claude-kit: AI-Assisted PCB Design Workflow